Temperature: 34*F – 100*F
Working Pressure: 30 psi – 120 psi
Flow Rate: 0.5 gpm
Capacity: 200-300 gallons depending on model (see box for details)
This system conforms to NSF/ANSI Standard 42
For Structural Integrity/Materials Safety/System Performance and the reduction of Chlorine, Tastes and Odors as verified and substantiated by test data. While testing was performed under laboratory conditions actual performance may vary.
This system has been tested according to NSF/ANSI 42 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42.
|NSF/ANSI Specified Challenge Concentration||Minimum %
|Chlorine Taste and Odor||2.0 mg/L +/- 10%||>/=50%|
After installation, flush the system by running water through the dispenser for approximately 5 minutes or until air is purged from the system. Some sputtering is normal as air is removed.
Do not use with water that is micro-biologically unsafe or of unknown quality. Read and follow instructions before installation and use of this product. Cartridge should be replaced every six months, at rated capacity, or sooner if a reduction in flow occurs.
The contaminants or other substances removed or reduced by this filter are not necessarily in all user’s water. The system and installation shall comply with applicable state and local regulations.
Manufacturers Limited Warranty. 30 Day Warranty.
This system is certified by IAPMO R & T to NSF/ANSI 42 for chlorine, taste and odor reduction.
Second Nature Brands, Inc.
333 Fayetteville St.
Raleigh, NC 27601
Still need help?
Please visit help.secondnature.com for answers to common questions or call us at 800.308.1186.